MS20270E
NOTES:
1. Dimensions are in inches.
2. Metric equivalents are given for information only.
3. Tolerances unless other wise noted are ± .015 inches (0.38 mm).
4. All dimensions to be met after plating.
5. Maximum diameter at the center of the joint shall not exceed the "A" dimensions by more than .060 inch (1.52 mm).
6. Remove all burrs and sharp edges.
FIGURE 1. Universal joint dimensions and configurations - Continued.
REQUIREMENTS
Dimensions and configurations, see figure 1. Part or Identifying Number (PIN):
MS20270 A 8 z
Plating designator (see table III)
Size (see figure 1)
Type (see figure 1)
Basic specification number
MS prefix
Classification. The universal joints shall be of the following class and types: Class 1: Light duty.
Type: See table I and figure 1.
TABLE I. Type designator.
Type designator |
End configuration |
A |
Square |
B |
Round |
Size: See table II and figure 1.
3
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business