INCH-POUND
MIL-DTL-20625B
27 August 2013
SUPERSEDING
MIL-U-20625A
28 March 1957
DETAIL SPECIFICATION
UNIVERSAL JOINTS, BLOCK TYPE, MECHANICAL REMOTE CONTROL SYSTEM
This specification is approved for use by all Departments and Agencies of the Department of Defense.
1. SCOPE
1.1 Scope. This specification covers universal joints of the block type for use in rotary type hand-operated or
intermittent power-operated valve remote control systems of the mechanical type.
Class A Steel
Class B Bronze
Class C Steel, Corrosion-Resistant
2. APPLICABLE DOCUMENTS
2.1 General. The documents listed in this section are specified in sections 3, 4, or 5 of this specification. This
section does not include documents cited in other sections of this specification or recommended for additional
information or as examples. While every effort has been made to ensure the completeness of this list, document
users are cautioned that they must meet all specified requirements of documents cited in sections 3, 4, or 5 of this
specification, whether or not they are listed.
2.2 Government documents.
2.2.1 Specifications, standards, and handbooks. The following specifications, standards, and handbooks form a
part of this document to the extent specified herein. Unless otherwise specified, the issues of these documents are
those cited in the solicitation or contract.
FEDERAL SPECIFICATIONS
QQ-N-281
-
Nickel-Copper Alloy Bar, Rod, Plate, Sheet, Strip, Wire, Forgings, and Structural and
Special Shaped Sections
DEPARTMENT OF DEFENSE STANDARDS
MIL-STD-130
-
Identification Marking of U.S. Military Property
MIL-STD-1916
-
DoD Preferred Methods for Acceptance of Product
(Copies of these documents are available online at https://quicksearch.dla.mil/ or https://assist.dla.mil.)
2.3 Non-Government publications. The following documents form a part of this document to the extent
specified herein. Unless otherwise specified, the issues of these documents are those cited in the solicitation or
contract.
Comments, suggestions, or questions on this document should be addressed to: Commander, Naval Sea Systems
Command, ATTN: SEA 05S, 1333 Isaac Hull Avenue, SE, Stop 5160, Washington Navy Yard DC 20376-5160 or
emailed to CommandStandards@navy.mil, with the subject line "Document Comment". Since contact information
can change, you may want to verify the currency of this address information using the ASSIST Online database at
https://assist.dla.mil.
AMSC N/A
FSC 3010
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business