MIL-DTL-6193D
INTERNATIONAL ORGANIZATION FOR STANDARDIZATION (ISO)
ISO 10012-1
-
Equipment, Quality Assurance Requirements for Measuring -
Part 1: Metrological Confirmation System for Measuring
Equipment
(Copies of these documents are available online at https://www.iso.ch or from the International
Organization for Standardization American National Standards Institute, 11 West 42nd Street, 13th Floor,
New York, NY 10036.)
NATIONAL CONFERENCE OF STANDARD LABORATORIES (NCSL)
NCSL Z540.1
-
Laboratories Calibration and Measuring and Test Equipment
(Copies of these documents are available online at https://www.ncsli.org or from the NCSL
International, 2995 Wilderness Place, Suite 107 Boulder, Colorado 80301-5404.)
SAE INTERNATIONAL
SAE-AMS-M-7866
-
Molybdenum Disulfide, Technical, Lubrication Grade
SAE AMS-QQ-P-416
-
Plating, Cadmium (Electro-deposited)
(Copies of these documents are available online at https://www.sae.org or from the SAE World
Headquarters, 400 Commonwealth Drive, Warrendale, PA 15096-0001.)
2.4 Order of precedence. In the event of a conflict between the text of this document and the
references cited herein (except for related specification sheets), the text of this document takes
precedence. Nothing in this document, however, supersedes applicable laws and regulations unless a
specific exemption has been obtained.
3. REQUIREMENTS
3.1 Specification sheets. The individual item requirements shall be as specified herein and in
accordance with the applicable specification sheet. In the event of any conflict between the requirements
of this specification and the specification sheet, the latter shall govern.
3.2 Qualification. Universal joints furnished under this specification shall be products that are
authorized by the qualifying activity for listing on the applicable qualified products list (QPL) before
3.3 Materials. Materials shall be as identified herein or as approved by the qualifying activity.
However, when a definite material is not specified, a material shall be used which will enable the
universal joint to meet the requirements of this specification. Acceptance or approval of any constituent
material shall not be construed as a guarantee of acceptance of the finished product.
3.3.1 Recycled, recovered, or environmentally preferable materials. Recycled, recovered, or
environmentally preferable materials should be used to the maximum extent possible provided that the
material meets or exceeds the operational and maintenance requirements, and promotes economically
advantageous life cycle cost.
3.4 Design and construction.
3.4.1 Dimensions. Dimensions shall be as specified in MS20270 and MS20271.
4
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business