Structureborne noise limits if different than those identified
(m)
(see 3.4,12)
Shaft spline missing tooth alignment versus rotational angle
(n)
for Category II and III actuators (see 3.5.14).
(o)
Position indicator markings, if required (see 3.5.12).
Presentation fluid, if other than specified (see 5.1.1),
(P)
Levels of preservation and packing required (see 5.1.2, 5.2,
(q)
and 5.3).
(r)
When fire-retardant material is required (see 5.1.2.1).
When fiberboard must meet flamespread and specific optic density
(s)
requirements (see 5.1.2.2).
When caseliners are not required for level A and level B packed
(t)
shipping containers (see 5.3.2.1.3).
(u)
When palletization is required (see 5.5).
Special marking required in addition to that specified in 5.6.2
(v)
(see 5.6.1).
6.3 Consideration of data requirements. The following data requirements
should be considered when this specification is applied on a contract. The
applicable Data Item Descriptions (DID's) should be reviewed in conjunction with
the specific acquisition to ensure that only essential data are requested/provided
and that the DID's are tailored to reflect the requirements of the specific
acquisition. To ensure correct contractual application of the data requirements,
a Contract Data Requirements List (DD Form 1423) must be prepared to obtain the
data, except where DoD FAR Supplement 27 475-1 exempts the requirement for a DD
Form 1423
DID Number
DID Title
Reference Paragraph
Suggested Tailoring
---
DI-DRPR-80651
3.4 and appendix
Engineering drawings
---
43
DI-NDTI-80809
Test/inspection
reports
---
4.4
DI-MISC-80678
Certification/
data report
The above DID's were those cleared as of the date of this specification, The
current issue of DoD 5010.12-L, Acquisition Management Systems and Data Require-
ments Control List (AMSDL), must be researched to ensure that only current,
cleared DID's are cited on the DD Form 1423.
6.4 Technical manuals. The requirement for technical manuals should be
considered when this specification is applied on a contract. If technical manuals
are required, military specifications and standards that have been cleared and
listed in DoD 5010.12-L, Acquisition Management Systems and Data Requirements
Control List (AMSDL) must be listed on a separate Contract Data Requirements List
(DD Form 1423), which is included as an exhibit to the contract. The technical
manuals must be acquired under a separate contract line item in the contract.
6.4.1 Additional requirements for technical manuals.
In addition to the
general requirements covered above, the following features apply to technical
manuals for rotary actuators,
18
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business